Beacon command, setting of beacon parameters (tracker mode)

beacon
Beacon setup
   Beacon <param> <value>
     SmartBeacon
     LowSpeed
     HighSpeed
     Distance
     StopSpeed
     MinTime
     MaxTime
     FixTime
     SlowTime
     TurnTime
     TurnAngle
     TxBatStatus
     TxTempStatus
     TxBatPrevent
     BatVolt
     TxStatusFrq
     TxQrvFreq
     TxQrvSplit
     TxQrvTone
     QrvFreq
     QrvFreqNarrow
     QrvFreqSplit
     QrvFreqTone
     Conf
     Init
     MicEmsg
     Save

beacon conf

Beacon Conf:
Smart Beacon configuration        : S-1
0: Fixed time interval.
1: Distance (accumulated).
2: Dynamic time by speed.
3: Distance (vector).

Fixed Time interval        S-0    : 120 Seconds
Distance  interval         S-1+3  : 800 meters
Low Speed  limit           S-2    : 4 km/H
High Speed limit           S-2    : 70 km/H
Stopped Speed limit        S-1+2+3: 4 km/H
Maximum Time interval      S-1+2+3: 120 Seconds
Minimum Time interval      S-1+2+3: 60 Seconds
Slow Time interval         S-1+2+3: 1200 Seconds
Turn Angle trigger level   S-1+2+3: 15 Degrees
Turn Time                  S-1+2+3: 2 Seconds
Tx Battery status          all    : 0
Tx Temperature status      all    : 0
Tx disable Battery low     all    : 0
Voltage low limit          all    : 0 mV
Tx Status interval 0-10    all    : 1/6
Tx QRV frequency           all    : 0
Tx QRV frequency Split     all    : 0
Tx QRV frequency Tone      all    : 0
QRV frequency              all    :
QRV frequency Narrow       all    : 0
QRV freq split -9900/+9900 all    : 0000 kHz
QRV freq tone   000/251    all    : 0
MicE message 0-7           all    : Off Duty
Execute 'beacon save' to store in flash.