The software functions of KissOZ

The minimum hardware to support the software is the STM32M4F platform. This platform is totally sw defined, all decoding of modulations supported is done in the cpu.

Functional overview:

• Help           : This command, lists all available commands.
• tty            : Show or change tty baudrate.
• rif            : Display and control radio interface configuration.
• info           : Display firmware version and build information.
• systime        : Display system time.
• reset          : Reset application (cold start).
• $GPGGA         : Input NMEA $GPGGA message.
• $GPRMC         : Input NMEA $GPRMC message.
• $GPVTG         : Input NMEA $GPVTG message.
• gpsp           : Display current GPS data information.
• bootlock       : Lock to bootloader at next reset.
• vcc            : Display VCC voltage.
• vbat           : Display Vbat voltage.
• 3v3            : Display 3v3 voltage.
• temp           : Display CPU temperature.
• demodc         : Display correlator tables.
• rxhexdump      : Display and control rxhexdump output.
• monitor        : Display and control kiss monitor output.
• sine           : Display and control DAC sine wave output.
• txtune         : Tx output calibration and test.
• txhexdump      : Display and control txhexdump output.
• modem          : Display and set modem configuration.
• kiss           : Activate KISS protocol on current interface.
• mod            : Display and configure modulation type.
• trkconfig      : Display and set Tracker mode.